Seven Useful Tips From Experts In Juniper Firewalls

Seven Useful Tips From Experts In Juniper Firewalls

Juniper Networks is considered the leading network technology provider with the most excellent firewall solutions. Technology continues to advance every day, and perhaps that is why Juniper regards each access point and switch as untrusted. That is why it is necessary the understand everything about Juniper firewalls. We did some research and below are the seven useful tips from experts in Juniper firewalls.


  1. Troubleshooting

You have probably done this several times on your computer. You may need to do this on Juniper firewalls as well. There are several clear up coAmmands that you can run to troubleshoot problems on Juniper firewalls. Some these debugs you can use include:

Trace ike detail: When setting up the VPN, display all the VPN messages between two devices. It helps to spot issues between 3rd party and Juniper firewalls.

Trace flow basic: This debug command contributes to displaying the traffic flow through the firewall, allowing for policy selection, troubleshooting course selection, any address conversion and whether the firewall receives the packet.

  1. Analyze firewall logs

One thing you should understand about Juniper firewalls is that they have references that link back to the rules being prompted. Therefore it is necessary to analyze firewall logs and configurations as it helps separate covered and redundant idle rules in the device.


  1. Use a simple interface

Handling the Command Line Interface (CLI) can be difficult. You, therefore, need an easy to use interface and provides an easily understandable combined view to spot discrepancies quickly.


  1. Understand Juniper packet flow

It is crucial that you acquaint yourself with the Juniper handles packet flows. This is especially important when you use policy based destination NAT.


  1. Use help command

If you need information, help reference command shows summary information for the suggested configuration statement. If you are looking for instructions and information on specific command, the help topic command offers usage instructions.


  1. Use keyboard arrows to navigate

Using the keyboard is the easiest way to navigate to the Command Line Interface. But you need to understand how the keys work. The keyboard gives you control.


  1. Commit configuration changes

Committing the configuration changes before they get active gives you the flexibility while working on the Command Line Interface. In this case, there are some commands that you should use, and they include; commit comment, commit confirmed, and commit check.



While all these tips are meant to help you understand the Juniper firewall, it is important to note that any simple mistake can result in huge networks risks. It is therefore important to be careful when using these commands in configuration. We hope these will also assist you to use less time when you need to troubleshoot.

Leave a Reply

Your email address will not be published. Required fields are marked *